ISSN : 0376-4672
Purpose : The purpose of this study was to compare the marginal fit of monolithic zirconia restorations fabricated form the conventional and the digital impression technique. Materials and methods : Ten patients were restored with monolithic zirconia restorations fabricated from the digital and the conventional impression technique. Before definitive insertion, silicone replicas were produced from all twenty crowns. The silicone replicas were cut in three sections; each section was evaluated at two points. The measurement was carried out by using a measuring microscope (Olympus BX 51) and I-Solution. Data from the silicone replica scores were analyzed by Shapiro-Wilk test for normal distribution and the t-test for equality of two population’s mean. All tests were performed with -level of 0.05. Results : The average marginal gaps of monolithic zirconia restorations were 133.81 36.46 for the conventional impression technique, 90.07 9.47 for the digital impression technique. No statistical differences were found between the two impression techniques Conclusion : Both prostheses presented clinically acceptable results with comparing the marginal fit.
The most valuable site of laser treatment is analgesic effect and fast healing process. If we understand an use this advantage correctly, it will helpful in relationship with patients and hospital management. So this study reported clinical cases about laser used in esthetic treatment with literature review. Periodontal treatment using laser was taken for patient who complain about gingival swelling during orthodontic treatment. And, esthetic plastic treatment using laser for alveoar reduction was taken for patient who complained about esthetic problem of maxillary gingiva. The treatment using laser can shorten the inconvenience and complicated treatment process and minimize patient’s fear and discomfort during treatment procedure. So patients and clinicians can expect competent result in clinical cases. The laser for esthetic treatment was valuable
Laser means “Light amplification by stimulated emission of radiation”. Laser have unique characteristics according to wavelength. Wavelenth of Waterlase is 2780nm and it can be absorbed to water and hydroxyapatite. When laser is applied to some material, its temperature goes up due to laser's energy. But in dental treatment high temperature is not good for teeth. High temperature can make dental pulp and bone necrosis. Waterlase can be absorbed to water droplet, so when it burst, it can cut soft and hard tissue without raising temperature. so it is so proper to dental treatment
Mess removal, electrocoagulation, cryosurgery are conventional methods in the treatment of various oral mucosal diseases. However, there are several problems or complication during or after surgery using conventional tools. Recently, LASER gradually become useful tool in the surgery of oral mucosal diseases. Of the LASER, carbon dioxide-mediated LASER is widely used one. Carbon dioxide LASER has many advantages such as good bleeding control, decreased damage to adjacent tissue, decreased pain and swelling, reduced scar formation, even bacteriocidal effects. In this reports, the author describe pros and cons of LASER, especially focused on carbon dioxide, and shed light on the field of LASER application in treatment of various oral mucosal diseases.
