ISSN : 2233-8292
워터젯은 콘크리트와 암석 절삭에 적합하며 소음과 진동이 적어 도심지 시공에 널리 활용되는 기술이다. 최근 한국원자력연구원은 처분터널 내 공학적방벽의 열-수리-역학적 복합거동 현장시험의 콘크리트 플러그를 교란 및 손상 없이 해체하기 위해 연마재 워터젯 기술을 채택 및 적용하였다. 본 연구에서는 플러그 해체를 통한 연마재 워터젯의 터널 내 적용성을 평가하였고, 절삭 결과를 개발된 절삭 모델 결과와 비교하였다. 현장 적용성에 관해서는, 워터젯 활용은 경로선택이 용이하였으며 주변부의 추가적인 교란을 발생시키지 않았다. 펌프의 소음은 공회전 시 64.9 dB로 국내 생활소음 ‧ 진동의 규제기준을 만족하였으나 공중 분사 및 절삭 시에는 터널 내에서 측정되어 그 기준을 상회한 것으로 나타났다. 절삭모델 검증을 위해 연마재 워터젯의 반복 절삭, 유량, 연마재 투입량 및 이격거리를 주요 변수로 선정하였고 절삭 모델로 계산된 절삭 부피와 측정된 부피의 오차는 1회 절삭 시 12~13%, 2회 절삭 시 16%를 보였다. 절삭 깊이와 폭은 이격거리에 큰 영향을 받았으며, 이격거리가 작을수록 오차가 감소하는 경향을 보였다.
Waterjet has been comprehensively used in urban areas owing to a suitable technique for cutting concrete and rock, and low noise and vibration. Recently, the abrasive waterjet technique has been adopted and applied by the Korea Atomic Energy Research Institute to demolish concrete plugging without disturbing and damagingIn-situ Demonstration of Engineered Barrier System in the disposal research tunnel. In this study, the use of abrasive waterjet in the tunnel was evaluated for practical applicability and the existing cutting model was compared with the experimental results. As a variable for waterjet cutting, multi-cutting, water flow rate, abrasive flow rate, and standoff distance were selected for the diversity of analysis. As regarding the practical application, the waterjet facilitated path selection for cutting the concrete plugging and prevented additional disturbances in the periphery. The pump’s noiseat idling was 64.9 dB which is satisfied with the noise regulatory standard, but it exceeded the standard at ejection to air and target concrete because the experiment was performed in the tunnel space. The experimental result showed that the error betweenthe predicted and measured cutting volume was 12~13% for the first cut and 16% for second cut. The standoff distance had a significant influence on the cutting depth and width, and the error tended to decrease with decrement of standoff distance.