- 권한신청
- P-ISSN2233-8292
- E-ISSN2287-4747
- KCI
복합 처분환경 모사조건에서의 KURT 화강암의 역학적 물성 변화 평가
Evaluation of mechanical properties of KURT granite under simulated coupled condition of a geological repository
김진섭 (한국원자력연구원)
김건영 (한국원자력연구원)
권상기 (인하대학교)
- 다운로드 수
- 조회수
초록
심부 지하환경 조건에서 측정된 암석물성의 사용은 고준위폐기물처분장의 장기 안전성 평가 측면에서 해석의 신뢰성을향상시킬 수 있다. 본 연구는 지하처분연구시설(Korea atomic energy research institute Underground Research Tunnel, KURT)의 화강암(한국원자력연구원, 대전)을 대상으로 고준위폐기물 처분장에서 예상되는 복합환경 조건을 구현한 후암석의 역학적 물성 변화를 측정하였다. 실험은 심지층 처분환경이 모사되도록 열-수리-역학적 복합 환경(Thermo-Hydro- Mechanical, THM)이 조절될 수 있는 실험장치를 제작하였다. 다양한 복합 실험조건(M, HM, TM, THM)을 구현하여일축압축강도와 간접인장강도, 탄성계수, 포와송비 등의 암석물성을 측정한 후 그 결과를 분석하였다. 실험결과, 처분장근계암반 예상 온도범위 내에서는 KURT 화강암의 역학적 물성이 온도의 영향 보다 포화유무에 따른 변화가 더 큰 것을확인할 수 있었다. 또한, 동일한 온도 조건에서 포화 유무에 따른 일축압축시험 결과는 최대 약 20%의 상대적인 차이를보였으며, 간접인장시험 결과는 최대 13%의 차이가 발생하였다. 따라서 처분장의 장기거동에 따른 성능평가 및 안전성예측을 위해서는 기존의 상온 실내시험을 통해 도출된 암석물성을 사용하기보다 심부 지하환경을 반영한 암석의 복합물성을 활용하는 것이 해석의 신뢰도 향상에 기여할 수 있을 것이다.
- keywords
- 고준위 방사성폐기물장, THM 복합 환경, KURT 화강암, 암석의 역학적 물성 변화, High-level radioactive waste disposal repository, THM coupled condition, KURT granite, Change of mechanical rock property
Abstract
The rock properties measured under in-situ geological condition can be used to increase the reliability in numerical simulations with regard to the long-term performance of a high-level waste repository. In this study, the change in mechanical properties of KURT (Korea atomic energy research institute Underground Research Tunnel) granite was evaluated under the simulated THM (Thermo-Hydro-Mechanical) coupled condition due to a deep geological formation in the disposal repository. The rock properties such as uniaxial compression strength, indirect tensile strength, elastic modulus and Poisson’s ratio were measured under the coupled test conditions (M, HM, TM, THM). It was found that the mechanical properties of KURT granite is more susceptible to the change in saturation rather than temperature within the test condition of this study. The changes in uniaxial compression strength and indirect tensile strength from the rock samples of dried or saturated conditions showed the maximum relative error of about 20% and 13% respectively under the constant temperature condition. Therefore, it is necessary to use the material properties of rock measured under the coupled THM condition as input parameters for the numerical simulation of long-term performance assessment of a disposal repository
- keywords
- 고준위 방사성폐기물장, THM 복합 환경, KURT 화강암, 암석의 역학적 물성 변화, High-level radioactive waste disposal repository, THM coupled condition, KURT granite, Change of mechanical rock property
참고문헌
1. Ahrens, B., Duda, M., Renner, J. (2018), “Relations between hydraulic properties and ultrasonic velocities during brittle failure of a low-porosity sandstone in laboratory experiments”, Geophysical Journal International, Vol. 212, No. 1, pp. 627-645.
2. Atkinson, B.K. (1984), “Subcritical crack growth in geological materials”, Journal of Geophysical Research: Solid Earth, Vol. 89, No. B6, pp. 4077-4114.
3. Cho, H.J., Moon, J.K., Jeong, I.S. (2012), “A study on decreasing behavior of strength & elastic parameters due to water infiltration in rock cores (I)”, Journal of the Korean Geotechnical Society, Vol. 28, No. 9, pp. 69-83.
4. Cho, W.J., Kim, J.S., Kim, G.Y. (2019), “Effects of excavation damaged zone on thermal analysis of multi-layer geological repository”, Journal of Nuclear Fuel Cycle and Waste Technology, Vol. 17, No. 1, pp. 75-94.
5. Choi, S.B., Lee, S.D., Jeon, S.W. (2018), “Experimental study on the change of rock properties due to water saturation”, Tunnel and Underground Space, Vol. 28, No. 5, pp. 476-492.
6. David, C., Menendez, B., Darot, M. (1999), “Influence of stress-induced and thermal cracking on physical properties and microstructure of La Peyratte granite”, International Journal of Rock Mechanics and Mining Sciences, Vol. 36, No. 4, pp. 433-448.
7. Heo, J., Lee, J.C., Seo, J.B., Park, S.H., Park, J.C., Kwon, S.K. (2014), “Variation of thermal and mechanical properties of crystalline granite under saturated-loading condition”, Tunnel and Underground Space, Vol. 24, No. 3, pp. 224-233.
8. Hsu, S.C., Nelson, P.P. (1993), “Characterization of cretaceous clay-shales in North America”, Geotechnical Engineering of Hard Soils-Soft Rocks, Vol. 1, pp.139-146.
9. Huang, Y.H., Yang, S.Q., Tina, W.L., Zhao, J., Ma, D., Zhang, C.S. (2017), “Physical and mechanical behavior of granite containing pre-existing holes after high temperature treatment”, Archives of Civil and Mechanical Engineering, Vol. 17, No. 4, pp. 912-925.
10. IAEA (1981), Recommendations on underground disposal of radioactive wastes, Basic Guidance, Safety Series 54.
11. Inada, Y., Kinoshita, N., Ebisawa, A., Gomi, S. (1997), “Strength and deformation characteristics of rocks after undergoing thermal hysteresis of high and low temperatures”, International Journal of Rock Mechanics and Mining Sciences, Vol. 34, No. 3-4, pp. 140.e1-140.e14.
12. ISRM (2007), The complete ISRM suggested methods for rock characterization, testing and monitoring:1974-2006, ISRM Commission on Testing Methods.
13. Jianhong, Y., Wu, F.Q., Sun, J.Z. (2009), “Estimation of the tensile elastic modulus using Brazilian disc by applying diametrically opposed concentrated loads”, International Journal of Rock Mechanics and Mining Sciences, Vol. 46, No. 3, pp. 568-576.
14. Kim, G.Y., Kim, S.J., Koh, Y.K., Bae, D.S. (2004), “Mineralogical characteristics and genesis of phlogopite in the talc deposits of the Chungnam area, Korea”, Journal of the Mineralogical Society of Korea, Vol. 17. No. 3, pp. 221-233.
15. Kitamura, K., Takahashi, M., Mizoguchi, K., Masuda, K., Ito, H., Song, S.R. (2010), “Effects of pressure on pore characteristics and permeability of porous rocks as estimated from seismic wave velocities in cores from TCDP Hole-A”, Geophysical Journal International, Vol. 182, No. 3, pp. 1148-1160.
16. Lee, C.S., Kwon, S.K., Choi, J.W., Jeon, S.W. (2011), “An estimation of the excavation damaged zone at the KAERI underground research tunnel”, Tunnel and Underground Space, Vol. 21, No. 5, pp. 359-369.
17. Lee, C.S., Yoon, S., Cho, W.J., Jo, Y.G., Lee, S.D., Jeon, S.W., Kim, G.Y. (2019), “Study on thermal, hydraulic, and mechanical properties of KURT granite and Gyeongju bentonite”, Journal of Nuclear Fuel Cycle and Waste Technology, Vol. 17, No. S, pp. 65-80.
18. Lee, H.K., Kim, Y.G., Lee, H.S. (1998), “A study on characteristics of jointed rock masses and thermo-hydro-mechanical behavior of rock mass under high temperature”, Tunnel and Underground Space, Vol. 8, No. 3, pp. 184-193.
19. Ozcelik, Y., Ozguven, A. (2014), “Water absorption and drying features of different natural building stones”, Construction and Building Materials, Vol. 63, No. 3, pp. 257-270.
20. Park, H.I., Lee, J.D., Jung, J.I. (1977), Manuscript of drawing paper on Yoosung of Korea geological map, Korea Institute of Geoscience and Mineral Resources, Daejeon, pp. 21.
21. Park, S.H., Heo, J., Lee, J.H., Park, J.C., Kwon, S.K. (2015), “An evaluation of the influence of the rock property change under saturated-loading conditions on rock stability”, Journal of the Korean Society of Mineral and Energy Resources Engineers, Vol. 52, No. 3, pp. 309-321.
22. Park, S.H., Kim, J.S., Kwon, S.K. (2018), “Investigation of the development of an excavation damaged zone and its influence on the mechanical behaviors of a blasted tunnel”, Geosystem Engineering, Vol. 21, No. 3, pp. 165-181.
23. Török, A., Török, Á. (2015), “The effect of temperature on the strength of two different granites”, Central European Geology, Vol. 58, No. 4, pp. 356-369.
24. Török, Á., Văsărhelyi, B. (2010), “The influence of fabric and water content on selected rock mechanical parameter of travertine, examples from Hungray”, Engineering Geology, Vol. 115, No. 3-4, pp. 237-245.
25. Yoon, Y.K., Baek, Y.J., Jo, Y.D. (2011), “Effects of temperature and water pressure on the material properties of granite & limestone from Gagok mine”, Tunnel and Underground Space, Vol. 21, No. 1, pp. 33-40.
26. Zhao, Y., Wan, Z., Feng, Z., Yang, D., Zhang, Y., Qu, F. (2012), “Triaxial compression system for rock testing under high temperature and high pressure”, International Journal of Rock Mechanics and Mining Sciences, Vol. 52, pp. 132-138.
27. Zhou, Z., Cai, X., Zhao, Y., Chen, L., Xiong, C., Li, X. (2016), “Strength characteristics of dry and saturated rock at different strain rates”, Transactions of Nonferrous Metals Society of China, Vol. 26, No. 7, pp. 1919-1925.
- 다운로드 수
- 조회수
- 0KCI 피인용수
- 0WOS 피인용수