- P-ISSN 1225-0163
- E-ISSN 2288-8985
- P-ISSN1225-0163
- E-ISSN2288-8985
- SCOPUS, ESCI, KCI
Article Detail
Home > Article Detail
Results of round robin test for specific surface area
Analytical Science and Technology / Analytical Science and Technology, (P)1225-0163; (E)2288-8985
2011, v.24 no.6, pp.503-509
https://doi.org/10.5806/AST.2011.24.6.503
&
(2011). Results of round robin test for specific surface area. Analytical Science and Technology, 24(6), 503-509, https://doi.org/10.5806/AST.2011.24.6.503
- Downloaded
- Viewed
Abstract
Specific surface area is becoming a very important factor when newly developed advanced nanomaterials are evaluated. But there have been many differences in results when measuring specific surface areas,depending on the measuring equipments and analysis method. To verify the reliability of the specific surface area measurement device supplied within the country, Round Robin Test (RRT) has been done at 21 affiliated research institutes. As a result, it was found that several institute had problems in measuring of gas adsorption amount in measuring equipment, and this proved the need for certified reference material (CRM). Furthermore,it was also found that the results from BET analysis is easily swayed by the analyst’s subjectivism, and the calculated results may differ up to 16% in case of CRM I depending on the selection range of BET analysis. So this showed that a standard guideline for BET constant C value and fitting correlation coefficient R is needed,to properly select range in BET analysis. The experience in RRT, distribution of CRM, and standardized procedure would result in improved reliability in industrial processes, and thus, would contribute to the quality management, the productivity improvement, the safety evaluation, and the new material development.
- keywords
- specific surface area, round robin test, certified reference materials, BET model, BET constant C value
Reference
1
1. S. J. Gregg and K. S. W. Sing, ‘Adsorption, Surface Area and Porosity’, Academic Press, 1982.
2
2. J. G. Dash, ‘Films on Solid Surfaces’, Academic Press, New York, 1975.
3
3. Paul A. Webb and Clyde Orr, ‘Analytical Methods in Fine Particle Technology’, Micromeritics Co. USA, 1997.
4
4. B. I. Choi, H. Nham and W. S. Kim, Saemuli, 49(4), 303-310 (2004).
5
5. B. I. Choi, J. C. Kim, T. Kim, H. Nham and S. Y. Kwon, Anal. Sci. Technol., 18(1), 74-84 (2005).
6
6. V. A. Hackely, ‘Final Report: Interlaboratory Study for the Measurement of BET-Specific Surface Area Using an Industrially Relevant TiO2 Nanopowder’, VAMAS TWA-34, 2011.
7
7. ISO 9277 ‘Determination of the specific surface area of solid by gas adsorption using the BET method’, 1995.
8
8. KS L ISO 18757 ‘Fine ceramics-Determination of specific surface area of ceramic powders by gas absorption using the BET method’ 2002.
9
9. KS A 0094 ‘Determination of the specific surface area of powders by gas absorption method’, 1997.
Other articles from this issue
- Chip-based microcapillary HPLC for proteomic analysis
- Investigation on the techniques of quality control for radiation counting systems
- Analysis of volatile aroma compounds from vanilla perfume using headspace disk type monolithic material sorptive extraction
- Development of wet-sampler for collection and fractionation of micron-sized particles
- Evaluation of the proficiency testing results for brominated flame retardants in high impact polystyrene
- Analytical study on nickel content in ceramic, metal and plastic materials
- Photoluminescence properties of eight coordinated terbium(III) complexes
- A solid-state NMR study on the activity of an antimicrobial peptide, magainin 2
- Solubility of carbon dioxide in ionic liquids with methylsulfate anion
- The analytical study on synthesis and purification of high purity ionic liquid, 1-ethyl-3-methylimidazolium tetrafluoroborate
- Analysis of 2,3,7,8-substituted PCDDs, PCDFs, and DL-PCBs in muscle of crucian carp (Carassius auratus and Carassius cuvieri) from major rivers and lakes
- The characteristics of Mn-TiO_2 catalyst for visible-light photocatalyst
- Results of round robin test for specific surface area
- Acoustic technology-assisted rapid proteolysis for high-throughput proteome analysis
- Real-time monitoring for blending uniformity of trimebutine CR tablets using near-infrared and Raman spectroscopy
- Analysis of calmodulin binding property of IQ motifs of IQGAP1
- 2D-QSAR analysis for hERG ion channel inhibitors
- Prediction and analysis of acute fish toxicity of pesticides to the rainbow trout using 2D-QSAR
- more
Recommanded Articles
This website recommended the use the Chrome browser for journal website.